Electrical Testing

Circuit Breaker Testing

Coordination and oversight of electrical assessments and testing activities performed by qualified third parties. ARE supports planning, access coordination, documentation, and reporting.

Electrical Distribution System Testing and Maintenance Service

HIGH CURRENT TESTING - PRIMARY INJECTION

It is necessary to periodically test your low voltage circuit breakers for proper response under overload and fault current conditions. Primary injection testing is the only means of providing an accurate test of over current devices and current transformers. This verifies their settings and ensures that the electrical distribution system is properly protected. A complete system test is performed on all circuit breakers with static trip devices.

SECONDARY CURRENT INJECTION TESTING

Secondary current injection tests are performed using specially designed power supply units and test sets. Each equipment manufacturer has their own specific test set and power supply. Secondary injection testing only tests the solid-state trip unit, the test allows checking of the trip unit without using primary current.  Secondary current testing is normally done when the circuit breaker is closed but is not carrying any current. If the secondary current injection testing show that the solid-state trip unit is not functioning properly, the trip unit should be replaced. Andy Ramos Electric LLC  has a full range of secondary current injection test sets from manufacturers like Eaton/Cutler Hammer, Square D, Siemens, ABB, General Electric (G.E.), and more.

INSULATION RESISTANCE TESTING (MEGGER TEST)

The insulation resistance test is a DC evaluation test of the insulation and gives a reliable indication of the presence of moisture, contamination or breakdown in the insulation. This test also establishes a benchmark for future comparative tests.

CONTACT RESISTANCE TESTING

If contacts are not maintained on a regular basis, resistance builds up due to repeated arcing, which in turn reduces the contacts’ ability to carry current. This test indicates the quality of mating of the contact surfaces and pivot points. Contact resistance should be maintained as low as possible to reduce localized heating and power losses.